1 files changed, 20 insertions, 7 deletions

diff --git a/keyboards/splitkb/kyria/rev1/config.h b/keyboards/splitkb/kyria/rev1/config.h
index a330dfc10..e19e8dfa9 100644
--- a/keyboards/splitkb/kyria/rev1/config.h
+++ b/keyboards/splitkb/kyria/rev1/config.h
@@ -57,18 +57,31 @@ along with this program.  If not, see <http://www.gnu.org/licenses/>.
 /*
  * Split Keyboard specific options, make sure you have 'SPLIT_KEYBOARD = yes' in your rules.mk, and define SOFT_SERIAL_PIN.
  */
-#define SOFT_SERIAL_PIN D2
 
-#define RGB_DI_PIN      D3
+#if defined(CONVERT_TO_PROTON_C)
+#    define SERIAL_USART_FULL_DUPLEX      // Enable full duplex operation mode.
+#    define SERIAL_USART_PIN_SWAP         // Swap TX and RX pins if keyboard is master halve.
+#    define SERIAL_USART_DRIVER      SD1  // USART driver of TX pin. default: SD1
+#    define SERIAL_USART_TX_PAL_MODE 7    // Pin "alternate function", see the respective datasheet for the appropriate values for your MCU. default: 7
+#    define SERIAL_USART_TX_PIN      D3
+#    define SERIAL_USART_RX_PIN      D2
+
+#    define RGB_DI_PIN               PAL_LINE(GPIOA, 3)
+#    define WS2812_PWM_DRIVER        PWMD2                  // default: PWMD2
+#    define WS2812_PWM_CHANNEL       4                      // default: 2
+#    define WS2812_PWM_PAL_MODE      1                      // Pin "alternate function", see the respective datasheet for the appropriate values for your MCU. default: 2
+#    define WS2812_DMA_STREAM        STM32_DMA1_STREAM2     // DMA Stream for TIMx_UP, see the respective reference manual for the appropriate values for your MCU.
+#    define WS2812_DMA_CHANNEL       2                      // DMA Channel for TIMx_UP, see the respective reference manual for the appropriate values for your MCU.
+#    define WS2812_DMAMUX_ID         STM32_DMAMUX1_TIM2_UP  // DMAMUX configuration for TIMx_UP -- only required if your MCU has a DMAMUX peripheral, see the respective reference manual for the appropriate values for your MCU.
+#else
+#    define RGB_DI_PIN D3
+#    define SOFT_SERIAL_PIN D2
+#endif
+
 #define RGBLED_SPLIT \
     { 10, 10 }
 #define RGBLED_NUM 20
 
-/* Mechanical locking support. Use KC_LCAP, KC_LNUM or KC_LSCR instead in keymap */
-#define LOCKING_SUPPORT_ENABLE
-/* Locking resynchronize hack */
-#define LOCKING_RESYNC_ENABLE
-
 #ifdef OLED_ENABLE
 #    define OLED_DISPLAY_128X64
 #    define SPLIT_OLED_ENABLE